1. Separate BIOS for IS7-G and IS7/IS7-E
2. Add CPU micro code
3. BIOS compiled date: 03/30/2005

1. Updated CPU micro code.
2. Added adjustable MAX & MIN multiplier item for certain retail INTEL CPUs.
3. Supports certain SATA CDROM when "OnChip Serial ATA" is running in "Enhanced Mode".
4. Changed "PWM Shutdown Temperature" as "Disabled", "PWM Warning Temperature" default to 95 degree C.
5. BIOS compile date: 11/23/2004

1. Updated CPU micro code.
2. BIOS compile date: 08/16/2004

1. Updated CPU Micro Code.
2. Shows MAC Address of onboard LAN chip in System Configuration section if "Onboard Network Controller" is disabled.
3. Added AWDFLASH v8.32 support for the "ALT+F2" hot key function.
4. Enhanced compatibility with certain power supplies.
5. Fixed an issue where the "OnChip SATA Raid Rom" item could not be disabled.
6. Calibrated CPU temperature.
7. Added "PWM Shutdown Temperature" item.
8. Added "PWM Warning Temperature" item.
9. BIOS compile date: 04/27/2004

1. Fixed the "CPU is unworkable" error message for P4 Prescott 2.4G (533MHz/ 1M L2/ 90nm) CPUs. Please follow the steps below to update the BIOS:
   1. Press <F1> key to continue booting when the "CPU is unworkable" error message shows on screen.
   2. Boot up the system from bootable floppy disk and then update BIOS.
2. BIOS compile date: 03/12/2004.

1. Fixed a problem where the system cannot boot into Windows if
   1. The OS is installed on the SATA hard disk when both SATA and PATA hard disks are present.
   2. The PATA hard disk is removed after the OS installation.
2. Updated Prescott CPU micro code.
3. Changed the default year to 2004.
4. Updated Intel OSB logo.
5. Enhanced compatibility with certain non-RAID cards.
6. Updated INTEL RAID BIOS to version 3.5.0.3003.
7. BIOS compile date: 02/23/2004.

1. Mise à jour du micro code du CPU.
2. Ajout du support pour Pentium 4 Extreme Edition.
3. Résolution du problème où le délai CAS ne peut pas être configuré manuellement lorsque le CPU:DRAM est paramétré à PSB8000/5:4 ou PSB8000/3:2.
4. Résolution du problème où le disque dur n'est pas reconnu si le OnChip SATA est configuré en "Combined Mode (Mode Combiné)" et choisit ensuite "RAID"
5. Résolution du problème où le système va redémarrer lorsque l'option "Resume by Alarm (Réveil par Alarme)" est activée et que l'utilisateur appuie sur l'interrupteur d'alimentation pour arrêter le système durant le POST.
6. Résolution du problème où la taille du HDD est détectée comme étant 136GB alors que des lecteurs SATA 200/250/300 GB sont connectes au SATA1 ou SATA2 (Canaux SATA ICH5).
7. Date de compilation du BIOS: 11/04/2003

BIOS ID:13

New Fixes/Features
1. Added support for IS7-G, IS7, and IS7-E.
2. Updated CPU micro code (CPU: 0F29H, ID=11H).
3. Added CPU multiplier 8X for engineering sample CPU and maximum CPU frequency 412 MHz.
4. Revised setup menu for OnChip Serial ATA.
5. Fixed on-chip SATA boot issue while another bootable hard drives exist and attached to IDE-1 or IDE-2.
6. Updated memory reference code and ICH5 BIOS spec to v1.2.
7. Fixed PS/2 mouse malfunctioning problem while the USB cable of Media XP attached to mainboard.
8. Fixed DOS 6.22 booting failure from FAT16 partition.
9. Fixed BIOS hang-up problem which is caused by specific CPU cooling fan reporting error RPM to BIOS when CPU FanEQ 60% enabled.
10. Revised the following default settings in BIOS setup page. - Bootable Add-in Device: PCI Slot Device - CPU FanEQ Active Temperature: 70 C - CPU Warning Temperature: 85 C
11. Added 80, 85, and 90 degrees C into "Shutdown Temperature".
12. Enabled "IDE Block Mode" and hided the option.
13. Revised ICH5R RAID BIOS display issue.
14. Revised power-on delay time from 4~5 seconds to 1~2 seconds after AC power lost and resumed.
15. Added description for "Bootable Add-in Device".
16. Fixed the problem that NB fan still reports full speed in PC Health page when "CPU FanEQ Speed Control" is enabled.
17. Added new option "IDE Bus Master".
18. Added description for "Shutdown when CPUFAN Fail".
19. Revised the wording of IDE channels inside the BIOS Setup. IDE Channel 0, 1, 2, and 3 are changed to 1, 2, 3, and 4.
20. Added new option "SATA RAID ROM" to setup both "OnBoard SATA" and "OnChip SATA".
21. Added new option "HDD Change Message" in Advanced BIOS Features and the default setting is "Disabled". If this option is changed to "Enabled",the system will show warning message and prompt for a confirmation whenone or more than one HDD had been added into or removed from the system.
22. Fixed "CPU THRM-Throttling" function.
23. Added new options "Refresh Cycle Time", "Read Delay Adjust (tRD Adj)", and "Command Per Clock (CPC)".
24. Changed the default setting of "Drive A" from "None" to "1.44M" after Load Fail-safe Defaults.
25. Changed the default setting of "OnCip Serial ATA" to "Auto".
26. Added "Game Accelerator" technology.
27. Revised the error reading of fan speed for specific CPU cooling fan when FanEQ 60% enabled.
28. Fixed the slow detection problem when HDD simulation card installed.
29. Fixed the problem that SMARTDRV.EXE malfunction in DOS 6.22 environment.
30. Fixed the problem that Windows 98 bootable floppy disk causes system hang up during loading CD-ROM driver when "OnChip Serial ATA" is set to"Auto" or "Enhanced Mode".
31. Removed the option "Force Update ESCD".
32. BIOS Compile Date: 6/10/2003.

BIOS ID:10

1. First release
2. BIOS Compile Date: 4/11/2003.