A: |
!!! WARNING !!! Not every DDR memory module can work
with the following aggressive setting. !!! WARNING !!!
- Load Optimized Defaults
- SoftMenu III Setup
2-1 CPU Operation Speed: User Define
Enhance For Benchmark:
Enabled
2-2 CPU Fast Command Decode:
Ultra (for 100 and 133
CPU)
Fast (for CPU overclocked
to 166 and above)
- Advanced BIOS Features
3-1 CPU L2 Cache ECC Checking: Disabled
3-2 APIC Mode: Enabled
- Advanced Chipset Features/DRAM Clock
4-1. DRAM Timing: Manual
DRAM CAS Latency: 2
Bank Interleave: 4
Bank
Precharge to
active(Trp): 2T
Active to
Precharge(Tras): 5T
Active to CMD(Trcd):
2T
(If the
system fails to boot up with above five settings, clear CMOS by yellow jumper
and load optimized default)
4-2. DIMM1&2 CMD Drive Strength: High (For Kingmax DDR module
compatibility only; keeps Auto for other DDR modules)
DIMM3&4 CMD Drive
Strength: High (For Kingmax DDR module compatibility only; keeps Auto for
other DDR modules)
4-3. Enhance DRAM Performance: Enabled
4-4. DRAM Access: 2T
(If the
system fails to boot up with above 2T setting, clear CMOS by yellow jumper and
load optimized default)
4-5. DRAM Command Rate: 1T Command
(1T Command
is a big challenge to most DDR modules, but if your module survived on this
setting, there will be a significant memory performance gain.)
- Advanced Chipset Features/AGP & P2P Bridge Control
5-1. AGP Aperture Size: 128M
5-2. AGP Driving Control: Manual
AGP Driving Value:
DA or EC
5-3. Enhance AGP Performance: Enabled
[Known issue] SYSmark2001 compatibility
<Symptom>
SYSmark2001 fails with error message: "The connection hotkey was not
installed...."
<Cause>
SYSmark2001 has USB keyboard compatibility issue, and it had been confirmed on
ASUS A7V333R with USB keyboard and USB mouse installed.
<Solution>
Remove USB keyboard while SYSmark 2001 reboots Windows 2000 the first time, and
keep no USB keyboard status until the benchmark completes.
* To report a broken link, please send a message to inform us. |